Hardware

We could talk about how the Zinc used in these nuts is only from the finest old-growth Zinc trees from across the globe and is hand picked only at the peak of the season. Or how they are expertly...

We could talk about how the Zinc used in these nuts is only from the finest old-growth Zinc trees from across the globe and is hand picked only at the peak of the season. Or how they are expertly hand-ground by a 6th generation master grinder. And how every nut passes a rigorous 19-point inspection process at each step of the process. And how each nut's dimensional variations can only be measured on the sub-atomic level. We could say all that, but it would be a lie. These are standard 4-40...

Metal short standoffs: 3/8" long x 1/4"OD. Used to get your proto board up off the table. #4-40 thread. Fits all development boards with available holes. Don't forget the screws! Related below. Set...

Metal short standoffs: 3/8" long x 1/4"OD. Used to get your proto board up off the table. #4-40 thread. Fits all development boards with available holes. Don't forget the screws! Related below. Set of ten

These nylon standoffs are 3/8" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off the table. Each standoff has an outer diameter of...

These nylon standoffs are 3/8" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off the table. Each standoff has an outer diameter of 6mm. Sold in packs of 10. Check below for matching screws.

These nylon standoffs are 3/4" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off the table. Sold in packs of 10. Check below for...

These nylon standoffs are 3/4" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off the table. Sold in packs of 10. Check below for matching screws.

These 4" long aluminum tubes have an outer diameter of 1", an inner diameter of 0.82", and a wall thickness of 0.09". When used with the mating tube clamps, these can be used for versatile...

These 4" long aluminum tubes have an outer diameter of 1", an inner diameter of 0.82", and a wall thickness of 0.09". When used with the mating tube clamps, these can be used for versatile structural support. Additionally, wires and cables can easily be run through the center. Features: Length - 4.0" OD - 1" ID - 0.82" Width - 0.09"