Power & Control

This is a waterproof DC-DC converter. With 16-36V DC input, it converts to 9V@5A which is a good supply for robots. |Features| Overvoltage protection Overcurrent protection Overheat protection...

This is a waterproof DC-DC converter. With 16-36V DC input, it converts to 9V@5A which is a good supply for robots. |Features| Overvoltage protection Overcurrent protection Overheat protection Short-circuit protection Waterproof and shockproof case High efficiency and less heat|Specification| Input Rage: 16-36V DC Output: 9V DC Output Current: 5A Size: 58 X 40.5 X 22mm(2.28x1.59x0.87") Efficiency: 96% Weight:0.09Kg Maximum working temperature:80 ? |ShippingList| 45W DC-DC Converter(FIT0169) x1 ...

     Invertor for EL wires or tapes, special designed for the Elecrow 8-channel EL Shield, can drive EL wire up to 15M . Specification Input voltage : 5V DC Output voltage :...

     Invertor for EL wires or tapes, special designed for the Elecrow 8-channel EL Shield, can drive EL wire up to 15M . Specification Input voltage : 5V DC Output voltage : 110V~210V AC Maximum driving ability: 15m EL wire Dimensions: 40mm x 32mm x 28mm Wire Length: 30cm (input) and 15cm (output) Interface: JST2.0 ...

This is the second version of the 9V to Barrel Jack Adapter. In this version the material for the 9V battery jack is hard plastic, which makes it easier to connect and disconnect You can plug a 9V...

This is the second version of the 9V to Barrel Jack Adapter. In this version the material for the 9V battery jack is hard plastic, which makes it easier to connect and disconnect You can plug a 9V battery into one end and connect the other end to anything with a 5.5x2.1mm, center-positive barrel jack. Use this cable to battery-power any device that needs 9V and has an on-board barrel jack - it works great for Arduinos, development boards, evaluation boards and more! |ShippingList| 9V to Barrel...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm(0.22x0.08"), center-positive female barrel jack. If you have a...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm(0.22x0.08"), center-positive female barrel jack. If you have a power supply with a barrel jack and want to plug it into a breadboard, this might be the simple solution. |ShippingList| DC Barrel Jack Adapter Female x1

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positive male barrel jack. If you need to connect bare...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positive male barrel jack. If you need to connect bare wires to a barrel jack on an Arduino or a development board, this might be the simple solution. With this Power Jack, you can feed various power source to your Arduino project, from 9V battery to 6xAA battery. A sample use is illustrated below. The 9V battery clip is also available at This picture is...